AH500 Module Manual
9-30
User message
Users can enter a user message. The message will be the contents of an email.
Attachment
The present value in a device in a CPU module can be an attachment to an email.
Email address and trigger
After the setting of email parameters is complete, users have to set email addresses to which
emails are sent, and select triggers for the sending of the emails.
Email address of a sender
The email address of a sender is an address to which an email is sent. (An email address is
composed of 63 English characters at most.)
Note: Only if there is a mail slave on a network can an email be sent correctly. An email is sent to a
mail slave, and then the mail slave sends the email to an address which is specified.
9.4.8 Intelligent Module Configuration─Data Exchange
CPU modules can exchange the data in devices which are specified through the data exchange
function of AH10/15EN-5A.
Data exchange setup