Chapter 10 DeviceNet Communication Module AH10DNET
10-29
10.7.3 Extension Baud Rate Setting
1. PC accesses the AH500 series CPU module via RS232 after connecting the device according
to the following figure.
RS232
DeviceNet Builder
CPU530-EN
PS05
P 05S
C U530-ENP
10DNET
AH10DNET-5A
2. Open DeviceNet Builder; then select “Setup” >> “Communication Setting” and then the following
dialog box appears, where select the already built driver.
Note: The driver is built through COMMGR. Please refer to section 8.1.3 in DeviceNet Builder
help file.
3. Select “Network” >> “Online” as below.
To Next Page
Loading...
