Chapter 10 DeviceNet Communication Module AH10DNET
10-33
5. Double click 10DNET icon in the above window and then the following dialog box appears,
where modify the starting addresses of the mapping areas of AH10DNET-5A.
Double click “Parameter of IO Mapping” on the above window; set the value in “Parameters of
IO mapping” and the set value is the starting address of the mapping area. Click “OK” after
setting is over.
Note: The set value is the starting address of the mapping area. Both of the length of the input
and output mapping areas is 500 words.
6. Select “Option” >> “Download” in the HWCONFIG interface and then the following dialog box
appears, where click “OK” to download the data.
To Next Page
