Chapter 11 DeviceNet Remote I/O Module AHRTU-DNET
11-27
The mapping starting addresses of each module can be classified into the following two cases.
The first case: The window is as below before the DeviceNet master has assigned the starting
address to AHRTU-DNET-5A (that is, AHRTU-DNET-5A has not been pulled into the scan list).
The offset for the starting address of each module can be set here. If the value in Start Address
is set to 1, it means that the offset for the mapping starting address of the module is ##+1.
To Next Page
Loading...
