Chapter 11 DeviceNet Remote I/O Module AHRTU-DNET
11-63
4. “10DNET” on the above window is the abbreviation of AH10DNET-5A.
Double click the AH10DNET-5A icon and then the parameter configuration dialog box of
AH10DNET-5A will pop up.
Set Start D device address mapped by INPUT area (input mapping starting address) and Start D
device address mapped by OUTPUT area (output mapping starting address) on the Parameters
of I/O Mapping interface as follows.
The two addresses are set to D500 and D1000 respectively in the example. Click “OK” after the
setting is completed.
To Next Page
Loading...
