Delta AH500 - Page 504

AH500 Module Manual
11-78
The communication format and the mapping relations between the AC motor drive and the DVP-SV
series PLC are shown below.
Product
Station
address
Communication
format
Read
address
CPU buffer
register
Write
address
CPU buffer
register
VFD 10
38400, ASCII
7, E, 1
16#2103 D1540
16#2000
16#2001
D1020~D1021
PLC 5
38400, ASCII
7, E, 1
D100~D109
M100~M109
D1550~D1559
Bit 0 in D1560~
bit 1 in D1561
D200~D204
M200~M204
D1030~D1034
Bit 0 in D 1040
~bit 1 in D1040
11.6.2 AH10SCM-5A Configuration
11.6.2.1 Configuration of AH10SCM-5A Parameters
Make the communication and call the DeviceNet Builder software by following the steps introduced
in section 5.2.1 and 5.2.2. And the start addresses of AH10DNET-5A for the input and output are
D1500 and D1000 respectively.
Select the network to be scanned in Project List and then click “Scan DeviceNet Network” button to
begin to scan the nodes on the network. If scanning fails, please ensure that the selected master
must be AH10DNET-5A in Project List.