Chapter 13 PROFIBUS Slave Module AH10PFBS
13-19
4. Double click “10PFBS” icon in the above window and then “Parameter Setting” dialog box
pops up. Click the left-side “Conversion Flags (Read Only)”; then click the place indicated
by the blue arrow in “Parameter Setting” dialog box and “Address” dialog box appears
immediately, where input the specified state register number. E.g. the input 0 indicates to
specify D0 as the state register. The state register of AH10PFBS-5A can only be D device.
The state register can be used to display whether the AH500 series CPU module is in RUN
or STOP state and whether the PROFIBUS communication of AH10PFBS-5A is normal.
See the introduction in section 8.3 for more details.
5. Click “File”>“Save” to save the hardware configuration.
To Next Page
Loading...
