Chapter 13 PROFIBUS Slave Module AH10PFBS
13-31
Add AH10PFBS-5A slave and configure the parameters
1. Select the PROFIBUS-DP bus as below; double click AH10PFBS-5A icon in the right
column of the following window and a new dialog box appears.
2. Select the node address of AH10PFBS-5A slave from the pull-down menu of “Address” in
the following new dialog box. The node address here must be consistent with that set by
the address switch of AH10PFBS-5A. Click “OK” after the node address setting is over.
To Next Page
Loading...
