Configure network interfaces Configure Wi-Fi interfaces
Digi TransPort WR Routers User Guide 179
Rogue Detection (Scan for unauthorised Access Points)
This Wi-Fi interface is a member of Bridge instance n and therefore bridged to the following
interfaces. The options are:
• Access Point. When the Wi-Fi interface is configured to be an Access Point, to forward packets
to and from the Wi-Fi interface, it must be bridged with an Ethernet interface using a Bridge
instance.
• Client
Interface
Interfaces that are currently members of the selected Bridge instance. Note that multiple Wi-Fi
interfaces can be members of the same Bridge instance.
Link this Wi-Fi client interface with Ethernet n
When the Wi-Fi interface is configured to be a client, it must be bridged to a particular Ethernet
interface.
This Wi-Fi rogue scanner will use Ethernet n
When the Wi-Fi interface is configured to be a rogue scanner, it uses the selected Ethernet
interface.
Hide SSID
When enabled, the SSID is not included in the beacon messages transmitted by the Wi-Fi
interface when in Access Point mode. This means that Wi-Fi clients cannot auto-detect the
Access Point.
Enable station isolation
When enabled, connected Wi-Fi clients cannot communicate with other Wi-Fi clients or Ethernet
hosts connected to this Access Point.
To Next Page
Loading...
