Configure network interfaces Configure Wi-Fi interfaces
Digi TransPort WR Routers User Guide 180
Wi-Fi CLI commands
How roam_threshold and roam_timeout parameters impact monitoring
If roam_threshold and roam_timeout are both non-zero, and the wifinode is configured in client
mode, monitoring of the signal strength of the link to the currently associated Access Point starts as
soon as the client has successfully connected to that Access Point. Monitoring of signal strength
stops at any time the client disconnects from the Access Point. If the RSSI of frames received from
the Access Point stays below the roam_threshold for roam_timeout consecutive seconds,
monitoring stops and the client starts scanning for Access Points.
Entity Instance Parameter Values Equivalent web parameter
wifinode 0 enabled on, off Enable this Wi-Fi interface
wifinode 0 descr String Description
wifinode 0 ssid String up to 32
characters
SSID
wifinode 0 mode ap, client,
rogue
Mode
wifinode o bridge_inst 0-3 This Wi-Fi interface is a member of Bridge
instance n and therefore bridged to the following
interfaces
eth n bridge_inst 0-3 Interface
eth n wificli on, off Link this Wi-Fi client interface with Ethernet n
eth n wificli_add Integer Link this Wi-Fi client interface with Ethernet n
wifinode 0 broadcastssid on, off Hide SSID
wifinode 0 isolation on, off Enable station isolation
wifinode n roam_threshold RSSI value None; command-line only
wifinode n roam_timeout Seconds None; command-line only
To Next Page
Loading...
