Configure network interfaces Configure Advanced interfaces settings: External modems and PPP
Digi TransPort WR Routers User Guide 320
ppp n pingip2 Valid IP address
a.b.c.d
Switch to sending pings to IP host
a.b.c.d after n failures
ppp n ip2count 0-2147483648 Switch to sending pings to IP host
a.b.c.d after n failures
ppp n pingresp 0-2147483648 Ping responses are expected within s
seconds
ppp n pingis off, on Only send Pings when this interface is
“In Service”
ppp n ping2cont off, on New connections to resume with
previous Ping interval
ppp n pingdeact 0-2147483648 Reset the link if no response is received
within s seconds
ppp n pingfreth0 off, on Use ETH 0 IP address as the source IP
address
ppp n pingresetint off, on Defer sending pings if IP traffic is being
received
ppp n off, on Limit the data transmitted over this
interface
ppp n dlwarnkb 0-2147483647 Issue a warning event after n XBytes
ppp n dlstopkb 0-2147483647 Stop Data from being transmitted
after n XBytes
ppp n dlrstday 0-255 Reset the data limit on the n day of the
month
ppp n When the link disconnects, indicate
that the connection failed if no IP
packets were received
ppp n sscnt 0-2147483648 Reset this interface if n packets are
transmitted and the connection has
been up for at least s seconds
ppp n sssecs 0-2147483648 Reset this interface if n packets are
transmitted and the connection has
been up for at least s seconds
ppp n lscnt 0-2147483648 Reboot the router after n consecutive
resets
ppp n rebootfails 0-2147483648 Reboot the router after n consecutive
connection failures
ppp n radius off, on Use RADIUS for authentication when
acting as a server
Entity Instance Parameter Values Equivalent web parameter
To Next Page
Loading...
