Digi TransPort WR31 - Page 319

Configure network interfaces Configure Advanced interfaces settings: External modems and PPP
Digi TransPort WR Routers User Guide 319
ppp n There is no explicit
parameter to enable or
disable this setting; it is
disabled by disabling the
ppp n echo n and
ppp n echodropcnt n
parameters
off, on Send LCP echo request packet to the
remote peer
ppp n echo 0-2147483648 Send LCP echo requests every s
seconds
ppp n echodropcnt 0-2147483648 Disconnect the link after n failed echo
requests
ppp None Generate Heartbeats on this interface
ppp n hrtbeatip Valid IP address
a.b.c.d
Send Heartbeat messages to IP
address a.b.c.d every h hrs, m mins, s
secs
ppp n hrtbeatint 0-2147483648 Send Heartbeat messages to IP
address a.b.c.d every h hrs, m mins, s
secs
ppp n hbipent Blank, PPP, ETH
Blank is default
Use interface x,y for the source IP
address
ppp n hbipadd Valid interface
number
0-2147483648
Use interface x,y for the source IP
address
ppp n hbiproute off, on Select transmit interface using the
routing table
ppp n hbimsi off, on Include IMSI information in the
Heartbeat message
ppp n hbgps off, on Include GPS information in the
Heartbeat message
ppp n None off, on Generate Ping packets on this
interface
ppp n pingsiz 0-2147483648 Send n byte pings to IP host a.b.c.d
every h hrs, m mins, s secs
ppp n pingip Valid IP address
a.b.c.d
Send n byte ping to IP host a.b.c.d
every h hrs, m mins, s secs
ppp n pingint 0-2147483648 Send n byte ping to IP host a.b.c.d
every h hrs, m mins, s secs
ppp n pingint2 0-2147483648 Send pings every h hrs, m mins, s
seconds if ping responses are not
being received
Entity Instance Parameter Values Equivalent web parameter