Configure system settings General system parameters
Digi TransPort WR Routers User Guide 657
CLI Pre-Login Banner
The router can display a banner before any login information is requested. The parameter
specifies the name of a file that is stored in the flash filing system and contains the text to be
displayed before the request for the username and password. This can be useful for displaying a
standard welcome message or any site-specific user instructions.
CLI Post-Login Banner
Once the user has successfully logged on to the router, a second message can be displayed. This
parameter specifies the name of a file containing the text to display. As above, the file may
contain site-specific instructions to be carried out once the user has logged in.
Allow CLI access from X.25 address n
Enables/disables logging into the router over an X.25 connection. The parameter n must be a
valid X.25 NUA (Network User Address).
With TRANSIP, use access level None, Low, Med, High, Super
Controls the security access level when using TRANSIP to access the router.
To Next Page
Loading...
