8. In the remote parking mode, the remote
parking function can be deactivated by pressing
the remote start/shutdown button on the
key.
9. After the remote park-in is completed, the
engine will be automatically shut down and the
vehicle will be automatically powered off.
Remote park-in/park-out via key
The key can be used to remotely drive the
vehicle into and out of a parking space. In this
way, the system can provide parking support for
the driver in narrow vertical parking spaces
(such as garages and parking buildings) where
the driver cannot get on and off the vehicle
comfortably.
1. After the engine is started, the transmission is
set to “P” position.
2. Press and hold the remote parking button
on the key until the hazard warning lamp
goes on. In this case, the function of park-
in/park-out via key is activated.
3. After the activation, according to the actual
parking situation, press the lock button or
unlock button on the key to move the
vehicle forward or backward in a straight line.
4. If suspension is required, press the remote
parking button on the key again. After the
suspension, the driver can continue to move the
vehicle forward or backward in a straight line by
pressing the lock button or unlock button on the
key.
5. In the remote parking mode, the remote
parking function can be deactivated by pressing
the remote start/shutdown button on the
key.
6. After the remote park-in/park-out is
completed, shut down the engine and lock the
vehicle through the smart key.
If park-out via straight advancing and straight
reversing is selected, parking is completed
when the vehicle is driven to the maximum
distance set by the system.
● In areas involving RF signal interference,
the remote parking function may be
abnormal or fail.
● After remote parking is completed, please
make sure that all windows are closed,
the vehicle is locked, and no occupants or
pets are left in the vehicle before leaving.
● When parking can be resumed during
remote parking, the vehicle will stop
slowly, and the driver shall continue to
operate the vehicle with driving safety
ensured.
Parking will be suspended under the following
conditions:
● The brake pedal is depressed;
● The accelerator pedal is depressed;
● One of the doors (including trunk lid) is open;
● The shift lever is turned;
● The remote parking button on the key
is pressed;
● The RF signal is interrupted.
When parking needs to be resumed after
suspension, the parking can be resumed by
pressing and holding the remote parking button
on the key for 2s;
To Next Page
Loading...