Adjustment before driving
Preparation before driving
Cooling
The A/C works only when the engine is running.
1. Press the button, and check that the
indicator lamp on the button comes on;
2. Turn the temperature knob on the control
panel counterclockwise or touch the temperature
down button on the MP5 display to set a
low temperature. Please set the desired
temperature according to the temperature value
shown on the A/C display;
3. Press the air volume up button . Please
set the desired air volume according to the on
the A/C display.
● If the outside temperature is very high, the
recirculation mode can be activated to
improve the cooling efficiency.
● If you need to activate the Max A/C
function, press the Max A/C button .
Then the A/C system will automatically
set the recirculation mode, and adjust the
temperature to the lowest and the air
volume to the maximum.
● If you feel hot air coming out of the air
outlets in summer, please set the A/C to
the recirculation mode and set the
temperature to the lowest value.
● If the button is pressed, the button
indicator lamp will come on, indicating
that the A/C compressor is working.
● During cooling, the condensate water in
the system is drained through the
prearranged pipe. Therefore, there will be
a puddle of water underneath the vehicle
when the vehicle stops.
● To maintain a good sealing performance
of the compressor, the A/C shall be
operated at least once per month.
● The A/C will always be useful in any
season because it can eliminate moisture
and vapor.
● To achieve good cooling effect, the
windows should be closed when the A/C
is turned on.
● However, the windows can be opened for
temporary ventilation and then closed as
the inside temperature rises when the
vehicle is kept under the sun for a long
time. The A/C operation will increase the
fuel consumption of the engine.
One-touch Max A/C
Press the Max A/C button , then the button
indicator lamp will light up, the A/C will activate
the maximum A/C function, and be adjusted
automatically as follows:
● Recirculation mode.
● Fan speed control knob in the maximum
position.
● Temperature set to the lowest.
● Panel mode .
When the Max A/C button is pressed
again, the A/C system will deactivate the Max
A/C function and return to the previous state.
After the inside temperature drops to a
suitable value, please try to deactivate the
Max A/C function so as to reduce energy
consumption and save fuel.
To Next Page
Loading...