Adjustment before driving
Preparation before driving
Heating
1. Press the button, and check that the
indicator lamp on the button goes out.
2. Slide the temperature control button on the
control panel upward or touch the temperature
up button on the MP5 display to set a high
temperature. Set the temperature according to
the demand;
3. Slide the fan speed control button on the
control panel upward or touch the fan speed up
button on the MP5 display to increase the fan
speed. Set the required fan speed according to
the demand.
● If the outside temperature is very low, the
recirculation mode can be activated to
improve the heating efficiency.
● If you need to set the maximum heating,
adjust the temperature and the air volume
to the maximum.
● In case of fogging on the windshield,
please press the front windshield
defogger button, instead of turning on the
heater for defogging when the A/C is off.
A/C refrigerant
The environmental impact of refrigerant added to
the A/C system has been considered thoroughly.
In case of the A/C repair, be sure to use special
refrigerant charger and lubricant. Because the
incompetent refrigerant or lubricant will cause
serious damage to the A/C system. (Refer to
page for details of recommended refrigerants)
Please go to an authorized dealer for the
overhaul of the A/C system.
Air filter
The air filter equipped on the A/C system is used
to remove the dirt, pollen, dust and others.
In order to maintain efficient heating, defogging
and ventilation of the A/C system, please clean
and replace the air filter at the maintenance
interval prescribed in this manual. For
replacement of the air filter, please contact an
authorized dealer.
The air filter shall be replaced when airflow
declines apparently or windows are prone to
fogging up if heater or A/C is applied.
To Next Page
Loading...