Adjustment before driving
Preparation before driving
Fog lamp
The fog lamps will come on only when the low
beam or high beam is on.
Rear fog lamp ON
When the rear fog lamps are off, push the fog
lamp control knob to the position. The
rear fog lamps will be turned on. Then the knob
automatically returns to , and the rear fog
lamps and the rear fog lamp ON indicator lamp
will come on at the same time.
The use of fog lamps is required only in rainy,
foggy, icy or snowy weather or in case of
poor visibility.
Fog lamp OFF
When the rear fog lamps are on, push the fog
lamp control knob to . The rear fog lamps
will be turned off. Then the knob automatically
returns to position.
Headlamp levelling
With the ENGINE START/STOP button set to
“ON” position, after the low beam is turned on,
the driver can adjust the headlamp beam height
by turning the manual leveling knob ① located
on the left side of the instrument panel.
Increase: Turn the knob upward to increase the
value;
Decrease: Turn the knob downward to decrease
the value.
Example of headlamp levelling
Position of
levelling
knob
Front
passenger and
driver
Driver and
passengers in
all rear seats
Driver and
passengers in
all seats
Driver and
passengers in
all seats
Front
passenger and
driver
The headlamp levelling only applies to the
low beam instead of the high beam.
Rain/light sensor*
The rain/light sensor (RLS) is located on the
front windshield near the interior rearview mirror.
If the RLS is covered by mud, oil, dust, etc., the
AHO function may not work properly.