Edge-Core ES3510MA

C HAPTER 14 | Security Measures
DHCP Snooping
– 349 –
◆ Store – Writes all dynamically learned snooping entries to flash
memory. This function can be used to store the currently learned
dynamic DHCP snooping entries to flash memory. These entries will be
restored to the snooping table when the switch is reset. However, note
that the lease time shown for a dynamic entry that has been restored
from flash memory will no longer be valid.
◆ Clear – Removes all dynamically learned snooping entries from flash
memory.
WEB INTERFACE
To display the binding table for DHCP Snooping:
1. Click Security, IP Source Guard, DHCP Snooping.
2. Select Show Information from the Step list.
3. Use the Store or Clear function if required.
Figure 200: Displaying the Binding Table for DHCP Snooping