C
HAPTER
15
| Basic Administration Protocols
Simple Network Management Protocol
– 382 –
WEB INTERFACE
To configure an SNMP group:
1. Click Administration, SNMP.
2. Select Configure Group from the Step list.
3. Select Add from the Action list.
4. Enter a group name, assign a security model and level, and then select
read, write, and notify views.
5. Click Apply
Figure 221: Creating an SNMP Group
To show SNMP groups:
1. Click Administration, SNMP.
2. Select Configure Group from the Step list.
3. Select Show from the Action list.
swMemoryUtiRisingThresholdNotifica
tion
1.3.6.1.4.1.259.8.1.11.2.1.0.109 This notification indicates that the
memory utilization has risen from
memoryUtiFallingThreshold to
memoryUtiRisingThreshold.
swMemoryUtiFallingThresholdNotific
ation
1.3.6.1.4.1.259.8.1.11.2.1.0.110 This notification indicates that the
memory utilization has fallen from
memoryUtiRisingThreshold to
memoryUtiFallingThreshold.
dhcpRougeServerAttackTrap 1.3.6.1.4.1.259.8.1.11.2.1.0.114 This trap is sent when receiving a
DHCP packet from a rouge server.
* These are legacy notifications and therefore must be enabled in conjunction with the corresponding traps
on the SNMP Configuration menu.
Table 28: Supported Notification Messages (Continued)
Model Level Group
To Next Page
Loading...
Need help?
General