Section 13 — Storage
ENSONIQ KT Musician’s Manual 7
SEQUENCER DATA
Sending Sequences/Songs out via MIDI Sys-Ex
1. Press the {EDIT_SEQ/PRESET} button.
2. Press the upper {9} button. The display shows:
Press ENTER to Store Seq Data
3. Press {ENTER}. The display now lets you choose which type of storage to use.
4. Use the {VALUE} buttons to select “Storage Type=MIDI SYS-EX,” as shown below:
Storage Type = MIDI SYS-EX
5. Press {ENTER}. The display now offers two choices:
Operation = SAVE
CURRENT SEQ/PSET
This command will transmit the currently selected sequence
or song as a MIDI System Exclusive message.
Operation = SAVE
CURRENT SEQ BANK
This command will transmit the entire contents of the
currently selected seq/preset bank as a MIDI System
Exclusive message. The dump contains data for the
complete set of 70 sequence locations and 30 song
locations.
6. Once you have selected either SAVE CURRENT SEQ/PSET or SAVE CURRENT SEQ BANK,
press {ENTER}. The display will show “Please wait . . . sending data” while the data is being
transmitted. When the transfer is complete, the display will return to the “Press ENTER to
Store Sequences” display.
To Next Page
Loading...
Need help?
General
