Section 13 — Storage
8 ENSONIQ KT Musician’s Manual
Receiving MIDI Sys-Ex Messages
The receiving of data dumps is initiated automatically by System Exclusive messages sent from
the transmitting unit. No front panel commands are necessary to receive dumps if the receiving
of System Exclusive messages is enabled. When Sys-Ex data for a bank of sounds is received via
incoming MIDI, it will always be written to the i:NT Sounds bank. When Sys-Ex data for a bank
of presets/seqs/songs is received via incoming MIDI, it will be written to the currently selected
Seq/Preset bank (if it’s r:ROM, it will be ignored).
To Enable Reception of System Exclusive messages:
1. Press the {SYSTEM"MIDI} button.
2. Press the lower {8} button.
3. Using the Data Entry Controls, set “SysEx=ON.”
When a single-sound MIDI Sys-Ex message is received, three things happen:
• the display briefly shows “Press ENTER to Save New Sound”.
• the new sound is placed in the edit buffer.
• the KT enters Edit Sound mode, with the Edit Sound LED flashing, so that you can hear, edit
and/or save the new sound that has been received.
When a one-Seq/Song message is received, the new sequence will be placed in the lowest-
numbered empty sequence location in the current sequencer bank. Or, if a song is received, it
will be placed in the lowest-numbered empty song location in the current sequencer bank. After
it is received, the new sequence or song will be selected.