CONFIDENTIAL
SHEET
103
NO.
SHEET
REVISION
E
TITLE
NEXT
104
TM-H5000
II
IIII
II
series
Specification
(STANDARD)
· When some characters in a line are double or more height, all the characters
on the line are aligned at the baseline.
·
ESC E
can also turn on or off emphasized mode. However, the setting of the
last received command is effective.
·
ESC
-
--
-
can also turn on or off underline mode. However, the setting of the last
received command is effective.
·
GS !
can also select character size. However, the setting of the last received
command is effective.
·
ESC M
can also select character font types. However the setting of the last
received command is effective.
[Default]
n
= 0
[Reference]
ESC -
,
ESC E
,
ESC M
,
GS !
ESC $
n
L
n
H
[Name] Set absolute print position
[Format] ASCII ESC $
n
L
n
H
Hex 1B 24
n
L
n
H
Decimal 27 36
n
L
n
H
[Range] 0 £
n
L
£ 255
0 £
n
H
£ 255
[Description] Sets the distance from the beginning of the line to the position at which
subsequent characters are to be printed.
· The distance from the beginning of the line to the print position is
[(
n
L
+
n
H
´ 256) ´ (vertical or horizontal motion unit)] inches.
[Notes] · Settings outside the specified printable area are ignored.
· The horizontal and vertical motion unit are specified by
GS P
.
· The
GS P
command can change the horizontal (and vertical) motion unit.
However, the value cannot be less than the minimum horizontal movement
amount, and it must be in even units of the minimum horizontal movement
amount.
· In standard mode, the horizontal motion unit (
x
) is used.
· In page mode, horizontal or vertical motion unit differs depending on the
starting position of the printable area as follows:
1 When the starting position is set to the upper left or lower right of the
printable area using
ESC T
, the horizontal motion unit (
x
) is used.
2 When the starting position is set to the upper right or lower left of the
printable area using
ESC T
, the vertical motion unit (
y
) is used.
[Reference]
ESC \
,
GS $
,
GS \
,
GS P
To Next Page
Loading...
Need help?
General