CONFIDENTIAL
SHEET
186
NO.
SHEET
REVISION
E
TITLE
TM-H5000
II
IIII
II
series
Specification
(STANDARD)
NEXT
187
FS &
[Name] Select Kanji character mode
[Format] ASCII FS &
Hex 1C 26
Decimal 28 38
[Description] Selects Kanji character mode.
[Notes] For Japanese Kanji model:
· This command is effective only when the JIS code system is selected.
· When the Kanji character mode is selected, the printer processes all Kanji code
for each two bytes.
· Kanji codes are processed in the order of the first byte and second byte.
· Kanji character mode is not selected when the power is turned on.
· Using
FS C
, the Kanji character code system is selected.
For Chinese/Taiwanese Kanji model:
· When the kanji character mode is selected, the printer checks whether the
code is for Kanji or not, then processed the first byte and the second byte if the
code is for Kanji.
· Kanji codes are processed in the order of the first byte and second byte.
· Kanji character mode is not selected when the power is turned on.
[Reference]
FS .
,
FS C
FS -
n
[Name] Turn underline mode on/off for Kanji characters
[Format] ASCII FS -
n
Hex 1C 2D
n
Decimal 28 45
n
[Range] 0 £
n
£ 2, 48 £
n
£ 50
[Description] Turns underline mode for Kanji characters on or off, based on the following values
of
n
for both receipt and slip.
n
Function
0, 48 Turns off underline mode for Kanji characters
1, 49 Turns on underline mode for Kanji characters (1-dot thick)
2, 50 Turns on underline mode for Kanji characters (2-dot thick)
[Notes] · The printer can underline all characters (including right- and left-side character
spacing), but cannot underline the space set by
HT
and 90° clockwise-rotated
characters.
· After the underline mode for Kanji characters is turned off by setting
n
to 0,
underline printing is no longer executed, but the previously specified underline
thickness is not changed. The default underline thickness is 1 dot.
To Next Page
Loading...
Need help?
General