CONFIDENTIAL
SHEET
71
NO.
SHEET
REVISION
E
TITLE
NEXT
72
TM-H5000
II
IIII
II
series
Specification
(STANDARD)
3.6 Hexadecimal Dumping
1) Hexadecimal dumping function
This function prints the data transmitted from the host computer in hexadecimal numbers
and in its corresponding characters.
2) Starting hexadecimal dumping
Open the cover and turn the power on while pressing the FEED button or executing
GS ( A
command, then close the cover. The printer first prints "Hexadecimal Dump" on paper roll
and prints the received print data in hexadecimal numbers and in its corresponding
characters.
NOTES: 1. If no characters correspond to the data received, the printer prints ".".
2. During hexadecimal dumping, any commands other than
DLE EOT
,
DLE
ENQ
, and
DLE DC4
do not function.
3. Insufficient print data to fill the last line can be printed by setting the printer off-
line.
3) Ending hexadecimal dumping
Hexadecimal dumping ends by turning the power off, pressing the FEED button three times,
or resetting the printer after printing has finished.
<Printing example>
Hexadecimal Dump
To terminate hexadecimal dump,
press FEED button three times.
1B 21 00 1B 26 02 40 40 1B 69 . ! . .
.
.i
1B 25 01 1B 63 34 00 1B 30 31 .
..c4..01
41 42 43 44 45 46 47 48 49 4A A B C D E F G H I J
*** completed ***
To Next Page
Loading...
Need help?
General