CONFIDENTIAL
SHEET
118
NO.
SHEET
REVISION
E
TITLE
NEXT
119
TM-H5000
II
IIII
II
series
Specification
(STANDARD)
ESC J
n
[Name] Print and feed paper
[Format] ASCII ESC J
n
Hex 1B 4A
n
Decimal 27 74
n
[Range] 0 £
n
£ 255
[Description] Prints the data in the print buffer and feeds the paper [
n
´ vertical or horizontal
motion unit] inches.
[Notes] · After printing is completed, this command sets the print starting position to the
beginning of the line.
· The paper feed amount set by this command does not affect the values set by
ESC 2
or
ESC 3
.
· The horizontal and vertical motion unit are specified by
GS P
.
· The
GS P
command can change the vertical (and horizontal) motion unit.
However, the value cannot be less than the minimum vertical movement
amount, and it must be in even units of the minimum vertical movement
amount.
· In standard mode, the printer uses the vertical motion unit (
y
).
· In page mode, this command functions as follows, depending on the starting
position of the printable area:
① When the starting position is set to the upper left or lower right
of the
printable area using
ESC T
, the vertical motion unit (y) is used.
② When the starting position is set to the upper right or lower left of the print
able area using
ESC T
, the horizontal motion unit (
x
) is used.
· The maximum paper feed amount is 1016 mm (40 inches). Even if a paper
feed amount of more than 1016 mm (40 inches) is set, the printer feeds the
paper only 1016 mm (40 inches).
[Reference]
GS P
To Next Page
Loading...
Need help?
General