CONFIDENTIAL
SHEET
136
NO.
SHEET
REVISION
E
TITLE
TM-H5000
II
IIII
II
series
Specification
(STANDARD)
NEXT
137
ESC f
t1 t2
[Name] Set slip paper waiting time
[Format] ASCII ESC f
t1 t2
Hex 1B 66
t1 t2
Decimal 27 102
t1 t2
[Range] 0 £
t1
£ 15
0 £
t2
£ 64
[Description] Sets the time that the printer waits for slip paper to be inserted and the time from
insertion of the slip to the start of printing.
·
t1
specifies the wait time for slip paper to be inserted.
·
t2
specifies time from insertion of the slip to the start of printing.
[Notes] · When the slip insertion wait time is set to be longer than the default value, the
problem such as paper jam may occur. The default value for the slip insertion
wait time is recommended.
· This command sets the slip paper wait time to [
t1
´ 1] minutes. If slip paper is
not inserted within this time, the printer cancels slip paper mode and selects the
paper roll.
· When
t1
is set to 0, the printer waits until slip paper is inserted.
· The printer starts operation [
t2
´ 0.1] seconds after detecting a slip.
· When either
t1
or
t2
is out of the specified range, this command is ignored and
the previously set value is not changed.
· In the following cases, the printer continues waiting for a slip to be inserted
(until the TOF sensor detects a paper present status).
① Waits for a slip to be inserted when a printing stop due to a paper-end is
enabled.
② Waits for a slip to be inserted when the printer recovers from an error.
· Using
DLE ENQ 3
cancels the slip waiting state. The data in the receive buffer
and the print buffer are cleared in this time.
[Default]
t1
= 0,
t2
= 5
To Next Page
Loading...
Need help?
General