Epson TM-H5000II series User Manual

CONFIDENTIAL
SHEET
165
NO.
SHEET
REVISION
E
TITLE
TM-H5000
II
IIII
II
series
Specification
(STANDARD)
NEXT
166
GS a n
[Name] Enable/Disable Automatic Status Back (ASB)
[Format] ASCII GS a
n
Hex 1D 61 n
Decimal 29 97 n
[Range] 0 £ n £ 255
[Description] Enables or disables ASB and specifies the status items to include, using
n as
follows:
Bit Off/On Hex Decimal Status for ASB
0 Off 00 0 Drawer kick-out connector pin 3 status disabled.
On 01 1 Drawer kick-out connector pin 3 status enabled.
1 Off 00 0 On-line/off-line status disabled.
On 02 2 On-line/off-line status enabled.
2 Off 00 0 Error status disabled.
On 04 4 Error status enabled.
3 Off 00 0 Paper roll sensor status disabled.
On 08 8 Paper roll sensor status enabled.
4 - - - Undefined.
5 Off 00 0 Slip paper sensor status disabled.
On 20 32 Slip paper sensor status enabled.
6, 7 - - - Undefined.
[Notes] · If any of the status items in the table above are enabled, the printer transmits
the status when this command is executed. The printer automatically transmits
the status whenever the enabled status item changes. The disabled status
items may change, in this case, because each status transmission represents
the current status.
· If all status items are disabled, the ASB function is also disabled.
· If the ASB is enabled as a default, the printer transmits the status when the
printer data reception and transmission is possible at the first time from when
the printer is turned on.
· The following four status bytes are transmitted without confirming whether the
host is ready to receive data. The four status bytes must be consecutive,
except for the XOFF code.
· Since this command is executed after the data is processed in the receive
buffer, there may be a time lag between data reception and status
transmission.

Epson TM-H5000II series Specifications

General

Brand	Epson
Model	TM-H5000II series
Category	Printer
Language	English