CONFIDENTIAL
SHEET
120
NO.
SHEET
REVISION
E
TITLE
NEXT
121
TM-H5000
II
IIII
II
series
Specification
(STANDARD)
ESC L
[Name] Select page mode
[Format] ASCII ESC L
Hex 1B 4C
Decimal 27 76
[Description] Switches from standard mode to page mode.
[Notes] · This command is enabled only when processed at the beginning of a line.
· This command has no effect in page mode.
· This command is available only when the paper roll is selected by
ESC c 0
.
· After printing by
FF
is completed or by using
ESC S
, the printer returns to
standard mode.
· This command sets the position where data is buffered to the position specified
by
ESC T
within the printing area defined by
ESC W
.
· This command switches the settings for the following commands (in which the
values can be set independently in standard mode and page mode) to those for
page mode:
① Set right-side character spacing:
ESC SP, FS S
② Select default line spacing:
ESC 2
③ Set line spacing:
ESC 3
· Only valve settings is possible for the following commands in page mode; these
commands are not executed.
① Turn 90° clockwise rotation mode on/off:
ESC V
② Select justification:
ESC a
③ Turn upside-down printing mode on/off:
ESC {
④ Set left margin:
GS L
⑤ Set printable area width:
GS W
· The following command is ignored in page mode:
À Execute test print:
GS ( A
· The following command is not available in page mode:
① Select paper:
ESC c 0
- Print non-volatile bit image:
FS P
® Define non-volatile bit image:
FS q
¯ Write to user NV memory:
FS g 1
° Initialize maintenance counter:
GS g 0
· The printer returns to standard mode when power is turned on, the printer is
reset, or
ESC @
is used.
[Reference]
FF
,
CAN
,
ESC FF
,
ESC @
,
ESC S
,
ESC T
,
ESC W
,
GS $
,
GS \
,
3.12
Page Mode
To Next Page
Loading...
