Epson TM-H5000II series

CONFIDENTIAL
SHEET
134
NO.
SHEET
REVISION
E
TITLE
TM-H5000
II
IIII
II
series
Specification
(STANDARD)
NEXT
135
ESC c 5 n
[Name] Enable/disable panel buttons
[Format] ASCII ESC c 5
n
Hex 1B 63 35 n
Decimal 27 99 53 n
[Range] 0 £ n £ 255
[Description] Enables or disables the panel buttons.
· When the LSB of
n is 0, the panel buttons are enabled.
· When the LSB of
n is 1, the panel buttons are disabled.
[Notes] · Only the lowest bit of
n is valid.
· When the panel buttons are disabled, none of them are usable when the printer
cover is closed.
· In this printer, the panel buttons are the FEED, FORWARD, REVERSE, and
RELEASE buttons.
· In the macro ready mode, the FEED and REVERSE buttons are enabled
regardless of the settings of this command; however, the paper cannot be fed
by using these buttons.
· When the cover is open, the following panel buttons are disabled regardless of
the settings of this command.
When the paper roll cover is open: FEED button is disabled
When the front cover is open: FORWARD, REVERSE, and RELEASE
buttons are disabled
[Default]
n = 0
ESC d n
[Name] Print and feed n lines
[Format] ASCII ESC d
n
Hex 1B 64 n
Decimal 27 100 n
[Range] 0 £ n £ 255
[Description] Prints the data in the print buffer and feeds
n lines.
[Notes] · This command sets the print starting position to the beginning of the line.
· This command does not affect the line spacing set by
ESC 2
or
ESC 3
.
· The maximum paper feed amount is 1016 mm (40 inches). If the paper feed
amount (
n x line spacing) of more than 1016 mm (40 inches) is specified, the
printer feeds the paper only 1016 mm (40 inches).
[Reference]
ESC 2
,
ESC 3