CONFIDENTIAL
SHEET
163
NO.
SHEET
REVISION
E
TITLE
TM-H5000
II
IIII
II
series
Specification
(STANDARD)
NEXT
164
GS \
n
L
n
H
[Name] Set relative vertical print position in page mode
[Format] ASCII GS \
n
L
n
H
Hex 1D 5C
n
L
n
H
Decimal 29 92
n
L
n
H
[Range] 0 £
n
L
£ 255
0 £
n
H
£ 255
[Description] Sets the relative vertical print starting position from the current position in page
mode.
· This command sets the distance from the current position to [(
n
L
+
n
H
´ 256)
´ vertical or horizontal motion unit] inches.
[Notes] · This command is ignored unless page mode is selected.
· When pitch
N
is specified to the movement downward:
n
L
+
n
H
´ 256 =
N
When pitch
N
is specified to the movement upward (the negative direction), use
the complement of 65536.
When pitch
N
is specified to the movement upward:
n
L
+
n
H
´ 256 = 65536 -
N
· Any setting that exceeds the specified printing area is ignored.
· The movement amount is calculated using the vertical motion unit of the
receipt.
· The horizontal and vertical motion unit are specified by
GS P
.
· The
GS P
command can change the horizontal (and vertical) motion unit.
However, the value cannot be less than the minimum horizontal movement
amount, and it must be in even units of the minimum horizontal movement
amount.
· This command function as follows, depending on the print starting position set
by
ESC T
:
①
When the starting position is set to the upper left or lower right of the
printing, the vertical motion unit (y) is used.
②
When the starting position is set to the upper right or lower left of the printing
area, the horizontal motion unit (x) is used.
[Reference]
ESC $
,
ESC T
,
ESC W
,
ESC \
,
GS $
,
GS P
, 3.12
Page Mode
To Next Page
Loading...
Need help?
General