Related Information
& “Installation Location and Space” on page 448
Using the Printer
❏ Never disassemble, modify, or attempt to repair the power cord, plug, printer unit, scanner unit, or options by
yourself, except as specically explained in the printer’s manuals.
❏ Unplug the printer and refer servicing to qualied service personnel under the following conditions:
e power cord or plug is damaged; liquid has entered the printer; the printer has been dropped or the casing
damaged; the printer does not operate normally or exhibits a distinct change in performance. Do not adjust
controls that are not covered by the operating instructions.
❏ Take care not to spill liquid on the printer and not to handle the printer with wet hands.
❏ If the LCD screen is damaged, contact your dealer. If the liquid crystal solution gets on your hands, wash them
thoroughly with soap and water. If the liquid crystal solution gets into your eyes, ush them immediately with
water. If discomfort or vision problems remain aer a thorough ushing, see a doctor immediately.
❏ Avoid touching the components inside the printer unless instructed to do so in this guide.
❏ Do not touch the areas indicated by caution labels inside the printer and the optional items.
❏ Avoid using a telephone during an electrical storm. ere may be a remote risk of electric shock from lightning.
❏ Do not use a telephone to report a gas leak in the vicinity of the leak.
❏ When connecting the printer to a computer or other device with a cable, ensure the correct orientation of the
connectors. Each connector has only one correct orientation. Inserting a connector in the wrong orientation
may damage both devices connected by the cable.
❏ Do not insert objects through the slots in the printer.
❏ Do not put your hand inside the printer during printing.
❏ Do not use aerosol products that contain ammable gases inside or around the printer. Doing so may cause re.
❏ Be careful not to trap your
ngers
when opening the covers, trays, cassettes, or when performing operations
inside the printer.
❏ Do not press too hard on the scanner glass when placing the originals.
❏ Always turn the printer o using the
P
button. Do not unplug the printer until the power light stops ashing.
❏ If you are not going to use the printer for a long period, be sure to unplug the power cord from the electrical
outlet.
❏ Do not sit or lean on the printer. Do not put heavy objects on the printer.
❏ When using the printer, make sure you lock the adjuster bolts of the printer.
❏ Do not move the printer when the adjuster bolts are locked.
Important Instructions
>
Important Safety Instructions
>
Using the Printer
17
To Next Page
Loading...
Need help?
General
