Removing Punch Scraps from the Booklet Finisher
When it is time to remove punch scraps, a message is displayed on the LCD screen. Follow the on-screen
instructions to remove punch scraps.
Ejecting Documents Continuously
When a given number of documents are ejected, the job stops to prevent paper jams. If you pull out the stopper
and lower it, you can eject documents continuously preventing the printer from detecting when the tray is full. In
this case the documents drop to the oor from the edge of the nisher booklet tray one by one.
Problems with the Booklet Finisher
The Booklet Finisher is not Recognized
Set the optional unit in the printer driver.
Related Information
& “Setting the Booklet Finisher in the Printer Driver” on page 353
Paper is not Ejected to the Booklet Finisher
❏ Remove any scraps of paper
le
inside the booklet
nisher.
❏ Remove any objects that are around the booklet nisher.
Paper or Staples Get Jammed in the Booklet Finisher
Check the error displayed on the control panel and follow the instructions to remove the jammed paper including
any torn pieces or jammed staples. e LCD screen displays an animation that shows you how to remove jammed
paper or staples. Next, select OK to clear the error.
Using Optional Items
>
Booklet Finisher
>
Problems with the Booklet Finisher
366
To Next Page
Loading...
Need help?
General
