Epson WorkForce Enterprise WF-C21000 Series - Page 419

Forwarding Report:
Prints a report aer forwarding a received fax document. Select Print to print every time a document
is forwarded.
Backup Error Report:
Prints a report when a backup error occurs on forwarding the sent fax to Backup Destination. You
can set the destination in Fax > Fax Settings > Backup. Note that the backup feature is available
when:
❏ Sending a fax in monochrome
❏ Sending a fax using the Send Fax Later feature
❏ Sending a fax using the Batch Send feature
❏ Sending a fax using the Store Fax Data feature
Fax Log Auto Print:
Prints the fax log automatically. Select On(Every 100) to print a log every time 100 fax jobs are
completed. Select On(Time) to print the log at a specied time. However, if the number of fax jobs
exceeds 100, the log is printed before the specied time.
Reception Report:
Prints a reception report aer you received a fax.
Print on Error prints a report only when an error occurs.
Attach Fax image to report:
Prints a Transmission Report with an image of the
rst
page of the sent document. Select On(Large
Image) to print the upper part of the page without reducing. Select On(Small Image) to print the
entire page reducing it to t onto the report.
Fax Log Layout:
Combine Send and Receive prints a Transmission Report and Reception Report on the same sheet
when you print Fax Log.
Selecting Separate Send and Receive prints a Transmission Report and Reception Report
separately when you print Fax Log.
Report Format:
Selects a format for fax reports in Fax > Menu tab > Fax Report other than Protocol Trace. Select
Detail to print with error codes.
Fax Log Output Method:
Select an output method for fax reports such as Save to Memory Device. When you select Forward,
select Destination from the contacts.
Basic Settings
You can nd the menu on the printer's control panel below.
Settings > General Settings > Fax Settings > Basic Settings
Product Information > Settings Menu List > General Settings
419