Synchronizing the Date and Time with Time Server
When synchronizing with the time server (NTP server), you can synchronize the time of the printer and the
computer on the network. e time server may be operated within the organization or published on the Internet.
When using the CA certicate or Kerberos authentication, time-related trouble can be prevented by synchronizing
with the time server.
1.
Access Web
Cong
and select the Device Management tab > Date and Time > Time Server.
2.
Select Use for Use Time Server.
3.
Enter the time server address for Time Server Address.
You can use IPv4, IPv6 or FQDN format. Enter 252 characters or less. If you do not specify this, leave it blank.
4.
Enter Update Interval (min).
You can set up to 10,080 minutes by the minute.
5.
Click OK.
Note:
You can
conrm
the connection status with the time server on Time Server Status.
Setting the Default Value for Scanning,Copying and Sending Faxes. (User
Default Settings)
You can set the default value for the functions.
You can set the following functions.
❏ Scan to Network Folder/FTP
❏ Scan to Email
❏ Scan to Memory Device
❏ Scan to Cloud
❏ Copy
❏ Fax
1.
Access Web Cong and select the functions for which you want to set the default value for the Scan/Copy tab
> User Default Settings.
Select the Fax tab > User Default Settings to set the default value for fax.
2.
Set each item.
3.
Click OK.
If the combination of the value is invalid, it is automatically
modied,
and then a valid value is set.
Administrator Information
>
Settings to Use the Printer
>
Making Basic Operation Settings for the Printer
534
To Next Page
Loading...
Need help?
General
