System manual CECX / Analog input module CECX-A-4E-V
CECX-II 19-10
19.5 Configuration
19.5.1 General information
A CECX-system needs data for the configuration of system performance,
its I/O-devices and interfaces. The system reads this data during the start-
up operation and allocates them to its components and devices.
Configuration data is created by included configuration tools.
19.5.2 Setting the address
The modules are addressed via the address switch. A maximum of 12
modules of the same type can be distinguished on one line.
The address switch is located on the right side underneath the lower cover.
The K-Bus plug is located underneath the upper cover.
0
1
F
2
3
4
5
6
7
8
9
A
B
C
D
E
1
Position of the address switch
1 ....Address switch
On leaving the factory all modules are set to address 0 and both covers are
closed.
Information
Modules of the same type that are installed within the same line must have
different address switch positions. Different modules (e.g. CECX-C-2G2
and CECX-A-4E-V) may have the same address switch positions.
To Next Page
Loading...
Need help?
General
