System manual CECX / SSI Interface module CECX-C-2G1
CECX-II 29-10
On leaving the factory all modules are set to address 0 and both covers are
closed.
Note
Modules of the same type that are installed within the same line must have
different address switch positions. Different modules (e.g. CECX-C-2G2
and CECX-C-2G1) may have the same address switch positions.
The lids for the K-Bus plug and the address switch must remain locked at
the last module in the line (to protect it against pollution and damage
through electrostatic discharge on contact).
29.7 Operating behavior
29.7.1 Operating mode of the module
29.7.1.1 Failure of supply voltage
If the supply voltage fails, the Module Status variable is set to TRUE.
29.7.1.2 Response to sensor failure
In case of sensor failure, the Channel Status variable of the affected
channel is set to TRUE.
When the fault is corrected the following status variable is again set to
FALSE.
29.8 Disposal
29.8.1 Disposal of the module
• The symbol with the crossed-out waste container means that electrical
and electronic devices including their accessories must not be dis-
posed of in the household garbage.
• The materials are recyclable in accordance with their labeling. By dis-
posing of such used devices correctly, you can ensure that they can be
reused, their raw materials recycled or put to another use, and you will
be making an important contribution to the protection of our environ-
ment!
To Next Page
Loading...
Need help?
General
