The Festo_EasyIP.lib library
13
(*send 1 output word from address %QW3 to the address %QW10 of the remote
station and request 1 input word from address %IW2 of the remote station and
write it to the local address %IW10. The communication status is written to
%MW600*)
1.5.4 Programming instructions
Access to input and output area
In certain circumstances, access to the input and output area is only possible via a pointer. This is
necessary in the following cases:
– write access to an input
– word access to 2 outputs/inputs created consecutively in the control configuration
The global variable list contains variables that specify the start of the input, output and flag area for this.
To Next Page
Loading...
Need help?
General
