System manual CECX / Commissioning of CoDeSys and control
CECX-II 7-20
7.8 First programming steps
1) Start the CoDeSys by clicking on the CoDeSys icon on the desktop or
with the command Start -> Programs -> Festo Software -> CoDe-
Sys V2.3 by Festo -> CoDeSys V2.3.
2) If you have already stored a new project, CoDeSys opens the project
and you can continue with the next action.
If you have not yet created a project or wish to create one, continue
as follows:
7.8.1 Creating a new project
1) Start with the command File -> New.
CoDeSys opens the window Target system settings.
2) Under Configuration select the desired control and confirm with OK.
A window for creating the first PLC_PRG module opens. Confirm with OK.
Now you can start with the coding of a new program.
Additional information: See CoDeSys online Help, chapter "We are writing a
small program".
To Next Page
Loading...
Need help?
General
