Fujitsu M10-4 - Page 156

Table 7-17
Active/cold addition work procedure (building block configuration only)
Item Work procedure Reference
1 Opening the rack door
2 Checking the operating condition of the
system and the I/O device usage status
"5.3 Checking the Operating Condition and Resource
Usage Status"
3 Releasing the assignment of a PCIe card "5.4.1 Releasing the assignment of I/O devices"
4
Releasing the chassis requiring maintenance
from the partition
"5.4.3 Releasing a chassis requiring maintenance from the
physical partition"
5
Releasing the chassis requiring maintenance
from the system
"5.8.1 Releasing of the SPARC M10-4S chassis (possible
only in a system with a building block configuration)"
6 Enabling access to the FRU requiring
maintenance
"5.9 Accessing an FRU"
7Mounting the installation part See the installation work procedures for each FRU (Chapters
8 to 10).
"Chapter 8 Maintaining the
PCI Express Cards"
"Chapter 9 Maintaining the CPU Memory Unit/Memory"
"Chapter 10 Maintaining the Internal Disks"
8
Restoring the chassis requiring maintenance "6.1 Restoring the Chassis"
9 Incorporating the chassis requiring
maintenance into the system
"6.2.1 Incorporation of the SPARC M10-4S chassis (possible
only in a system with a building block configuration)"
10 Diagnosing the chassis requiring
maintenance
"6.3.1 Diagnosing the system board" (*1)
"6.3.2 Diagnosing the crossbar unit and crossbar cables"
11 Incorporating the
chassis requiring
maintenance into a partition
"6.5.1 Incorporating a chassis into a physical partition"
12 Confirming that there is no problem with
the replacement FRU
"4.2.2 Identifying a failure" - "Checking the FRU status"
13 Restoring the logical domain "6.5.3 Restoring the logical domain to the pre-maintenance
state"
14 Closing the rack door
*1 Normally, the testsb command is executed during replacefru command processing. However, if that is canceled, diagnose the system
board before incorporating the chassis requiring maintenance into the physical partition.
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual
･
November 2014142