Fujitsu M10-4 - Page 178

1. Open rack door
3. Check operating condition of system and
I/O device usage status
4. Stop system
5. Enable maintenance of chassis requiring
maintenance
6. Remove target FRU
7. Restore chassis requiring maintenance
8. Perform diagnosis test
10. Return mode switch to original mode
11. Start system
12. Close rack door
Removal complete
2. Switch mode switch
9. Confirm that there is no problem with
chassis after removal
Figure 7-28
System-stopped/cold removal flow (for a single-chassis configuration)
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual
･
November 2014164