Fujitsu M10-4 - Page 179

Table 7-29
System-stopped/cold removal work procedure (for a single-chassis configuration)
Item Work procedure Referenc e
1 Opening the rack door
2 Switching the mode switch on the
operation panel to Service mode
"5.2 Switching the Mode Switch to Service Mode"
3 Checking the operating condition
of the system and the I/O device
usage status
"5.3 Checking the Operating Condition and Resource Usage Status"
4 Stopping the system "5.6 Stopping the Entire
System"
5 Enabling maintenance of the
chassis requiring maintenance
"5.9 Accessing an FRU"
6 Removing the target FRU See the removal procedures for each FRU (Chapters 8 to 10).
"Chapter 8 Maintaining the PCI Express Cards"
"Chapter 9 Maintaining the CPU Memory Unit/Memory"
"Chapter 10 Maintaining the Internal Disks"
7 Restoring the chassis
requiring
maintenance
"6.1 Restoring the Chassis"
8 Performing a diagnosis test "6.3.1 Diagnosing the system board"
9 Confirming that there is no
problem with the chassis after the
removal
"4.2.2 Identifying a failure" - "Checking the FRU status"
10 Returning the mode switch on the
operation panel to Locked mode
"6.6 Returning
the Mode Switch to Locked Mode"
11 Starting the system "6.8 Starting the Entire System"
12 Closing the rack door
Chapter 7 Maintenance Flow 165