Fujitsu PRIMERGY RX2520 M5

7 Hard disk drive (HDD) / solid state disk (SSD) 123
7.1 Safety notes 123
7.2 Basic information 124
7.3 Handling HDDs or SSDs without installation frame 125
7.3.1 2.5-inch HDD/SSD and 2.5-inch installation frame 125
7.3.2 2.5-inch HDD/SSD and 3.5-inch installation frame 126
7.3.3 3.5-inch HDD and 3.5-inch installation frame 128
7.4 3.5-inch HDD configurations 130
7.4.1 Overview of configurations 130
7.4.1.1 Configuration with up to four HDD modules 130
7.4.1.2 Configuration with up to eight HDD modules 131
7.4.1.3 Configuration with up to 12 HDD modules 131
7.4.2 Installing 3.5-inch HDD modules 132
7.4.3 Removing 3.5-inch HDD modules 135
7.4.4 Replacing a 3.5-inch HDD module 137
7.4.5 Replacing the 3.5-inch HDD backplane 139
7.4.6 Upgrading to 8x 3.5-inch HDD configuration 147
7.4.7 Replacing the 12x 3.5-inch HDD backplane 148
7.4.8 Replacing the SAS expander board 157
7.4.9 Replacing the connector card 162
7.4.10 Replacing the connector card 165
7.5 2.5-inch HDD/SSD configurations 167
7.5.1 Overview of configurations 167
7.5.1.1 Configuration with up to eight HDD/SSD modules 167
7.5.1.2 Configuration with up to 16 HDD/SSD modules 168
7.5.1.3 Configuration with up to 24 HDD/SSD modules 169
7.5.1.4 Configuration with additional PCIe-SSDs 170
7.5.2 Installing 2.5-inch HDD/SSD modules 172
7.5.3 Removing 2.5-inch HDD/SSD modules 175
7.5.4 Replacing a 2.5-inch HDD/SSD module 178
7.5.5 Installing 2.5-inch PCIe SSD modules 179
7.5.6 Removing 2.5-inch PCIe SSD modules 182
7.5.7 Replacing a 2.5-inch PCIe SSD module 184
7.5.8 Replacing a 8x 2.5-inch HDD backplane 185
7.5.9 Upgrading from 8x to 16x 2.5-inch HDD/SSD configuration 190
Content
RX2520 M5 Upgrade and Maintenance Manual