Fujitsu PRIMERGY RX2520 M5

▶
Remove all PSUs, see "Removing a hot-plug PSU" on page 106.
▶
"Getting access to the component" on page
47.
▶
"Removing the air duct" on page 58.
▶
"Removing the fan holder" on page 60.
▶
Remove all expansion cards, see "Removing the expansion card" on
page 237.
Before removing the expansion cards, take a note on the installation
slot number for each card. Ensure that you install the card again in
the slot it was located before the replacement.
▶
"Removing the crossbar" on page 62.
▶
Remove all memory modules, see "Removing a memory module" on
page 266.
Before removing the memory modules, take a note on the installation
slot number for each memory module. Ensure that you install the
memory modules again in the slot they were located before the
replacement.
▶
If applicable, remove the iRMC microSD card, see "Removing the iRMC
microSD card" on page 403
.
▶
If applicable, remove all M.2 SSDs, see "Removing the M.2 SSD" on
page 410.
Removing the system board
▶
Disconnect all cables from the system board.
System board and components
426 Upgrade and Maintenance Manual RX2520 M5