TX1310 M1
Upgrade and Maintenance Manual 131
Expansion cards and backup units
9.3.3.4 Concluding steps
Ê "Installing the side cover" on page 53
Ê "Connecting the server to the mains" on page 54
Ê "Switching on the server" on page 55
Ê "Enabling replaced components in the system BIOS" on page 70
Ê "Looking up changed MAC / WWN addresses" on page 76
Ê "Updating the NIC configuration file in a Linux environment" on page 73
Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
I Configuration of network settings should be performed by the
customer.
For further information, please refer to section "Note on network
settings recovery" on page 130.
Ê "Enabling BitLocker functionality" on page 74
Ê If applicable, "After replacing / upgrading LAN controllers" on page 77
To Next Page
Loading...
