Fujitsu PRIMERGY TX1310 M1 - Completing the Maintenance Task; Updating or Recovering the System Board BIOS; Enabling Option ROM Scan

68 Upgrade and Maintenance Manual TX1310 M1
Basic software procedures
5.2 Completing the maintenance task
5.2.1 Updating or recovering the system board BIOS
After replacing the system board, memory or a CPU, it is essential to upgrade
the BIOS to the latest version. The latest BIOS version is available from the
Fujitsu support internet pages at:
http://ts.fujitsu.com/support/ (EMEA market)
http://jp.fujitsu.com/platform/server/primergy/downloads/ (Japanese market)
I Fujitsu does not assume responsibility for any damage done to the
server or for the loss of any data resulting from BIOS updates.
5.2.1.1 Updating or recovering the system board BIOS
BIOS flash procedure
I For the Japanese market, follow the instructions provided separately.
Ê Perform the BIOS flash procedure as described in your server’s "BIOS
Setup Utility" reference manual.
BIOS recovery procedure
I For the Japanese market, follow the instructions provided separately.
Ê Perform the BIOS recovery procedure as described in your server’s "BIOS
Setup Utility" reference manual.
5.2.2 Enabling Option ROM scan
In order to configure an expansion card that has been installed or replaced, the
card’s Option ROM has to be enabled in the system board BIOS. The card’s
firmware is called by the system BIOS upon reboot and can be entered and
configured.