TX1310 M1
Upgrade and Maintenance Manual 55
Basic hardware procedures
4.7 Switching on the server
V CAUTION!
●
Before switching on the server, make sure the side cover is closed. In
order to comply with applicable EMC regulations (regulations on
electromagnetic compatibility) and to satisfy cooling requirements,
the server must not run while the side cover is removed
●
Follow the safety instructions in chapter "Important information" on
page 27.
Ê Connect all peripheral cables to the server.
Figure 16: Power button on the front panel
Ê Press the On / Off button to start up the server (1).
Ê Ensure that the LED in the On / Off button is lit green.
I For more information see section "Front panel and front USB" on
page 183.
Ê Perform the required procedures described in the concluding steps of each
upgrade or maintenance task.
햲
To Next Page
Loading...
