11.2.3 Removing processor
V CAUTION!
Processors are extremely sensitive to electrostatic discharge and must
be handled with care. After a processor has been removed from its
protective sleeve or from its socket, place it upside down on a
nonconducting, antistatic surface. Never push a processor over a
surface.
11.2.3.1 Preliminary steps
Ê "Disabling BitLocker functionality" on page 63
Ê "Shutting down the server" on page 40
Ê "Disconnecting the server from the mains" on page 41
Ê "Getting access to the component" on page 42
Ê "Removing the heat sink" on page 143
11.2.3.2 Removing a processor
I This description applies to the following procedures:
– Removing processor from a defective system board (see section
"Replacing the system board" on page 206)
Ê Remove the desired processor heat sink as described in section "Removing
the heat sink" on page 143.
Field Replaceable Unit
(FRU)
Hardware: 15 minutes
Software: 5 minutes
Tools: Tool-less
To Next Page
Loading...
