42 Upgrade and Maintenance Manual
TX1310 M1
Basic hardware procedures
4.4 Getting access to the component
V CAUTION!
●
Before removing or installing covers, turn off the server and all
peripheral devices. Also unplug all power cables from the outlet.
Failure to do so can cause electric shock.
●
In order to comply with applicable EMC regulations (regulations on
electromagnetic compatibility) and satisfy cooling requirements, the
server must not run while the side cover is removed.
●
For further safety information, please refer to chapter "Important
information" on page 27.
4.4.1 Removing the side cover
Figure 4: Removing the cover
Ê Pull up on the locking lever (1).
Ê Open the side cover (2).
Ê Remove the side cover (3).
햲
햳
햴
To Next Page
Loading...
