TX1310 M1
Upgrade and Maintenance Manual 163
Accessible drives
Figure 105: Connected points of the EMI spring of bay 2
Figure 106: Connected points of the EMI spring of bay 2
Ê Cut the three connected points of the EMI spring with a diagonal pliers.
Ê Remove the EMI spring.
Ê Install the RDX drive.
I The RDX drive is a little harder to insert than an ODD and the bezel of
the drive is touching the front panel.
V CAUTION!
You cannot re-install the EMI spring.
If you want to remove the RDX drive, you have to install a dummy drive
instead, refer to "Installing the dummy drive" on page 176.
To Next Page
Loading...
