Chapter 10: Set Preferences
Definium 5000 X-Ray System 5197809-1EN Rev. 4 (13 February 2008) 10-46
Operator Manual © 2008 General Electric Company. All rights reserved.
3. Press [ADD VIEW] or [EDIT VIEW].
The Add View (or Edit View) screen (1 of 2) appears.
4. Type a View Name. Do not use spaces. Use underscores ( _ ) to separate words.
5. From the Position View After drop-down list, select the placement of the view within the exam.
6. Select the Acquisition Type.
Available options are:
– Standard
–Bone
–Soft Tissue
7. Check if horizontal flip is to be applied when displaying the image.
8. Select the Anatomy.
NOTE: The selected anatomy will determine the image processing for the view. Be sure to select the
appropriate anatomy for the body part imaged.
9. Select the most appropriate View (AP, Lat, etc.).
The selected anatomy determines which views are available.
FOR TRAINING PURPOSES ONLY!
NOTE: Once downloaded, this document is UNCONTROLLED, and therefore may not be the latest revision. Always confirm revision status against a validated source (ie CDL).
To Next Page
Loading...
